The ice compartment high in a French door model's left door opened with its cover off, a small sensor clipped to the side of the ice maker and its thin wire running to a plug.

Kenmore Trio diagnostic code i5 Lo or i5 Hi

In the diagnostic mode of a Kenmore 111 Trio, i5 Lo or i5 Hi reports a failed ice maker temperature sensor.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Temperature sensors
  • Ice maker control and sensor repair
  • Source: Kenmore

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

What i5 Lo or i5 Hi
actually means.

In the diagnostic mode of a Kenmore 111 Trio, i5 Lo or i5 Hi reports a failed ice maker temperature sensor. Sears checks the wiring between the ice maker and the control board first, and because the sensor is part of the ice maker, a bad one means a new ice maker.

Kenmore ice maker display · also shown as i5 Lo, i5 Hi

What to do when i5 Lo or i5 Hi shows on the ice maker

Before you book,
in this order.

Each step comes from Kenmore's own guidance for i5 Lo or i5 Hi on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

Note whether the display reads i5 Lo or i5 Hi.

02

Exit diagnostic mode by pressing Lock.

03

Book a visit so the wiring and the sensor can be measured.

Still there?

It usually turns into ice maker control and sensor repair. Book with the code and the model number.

What not to do

i5 is not the ice room sensor, which is iD. It is also not a sign that the whole freezer is warm.

What you may
notice with it.

The ice maker problems i5 Lo or i5 Hi tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

Where i5 Lo or i5 Hi usually leads

Ice maker control and sensor repair.

Control board, thermistor or bin sensor · moderate to highest.

In Kenmore's own words

Ice maker temperature sensor failure
Sears PartsDirect: Kenmore 111 bottom-freezer error codes (Wayback copy, Nov 2019) Sears PartsDirect: Kenmore 111 bottom-freezer error codes (Wayback copy, Nov 2019)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Kenmore bottom-freezer Trio models whose number begins 111; the code is read in the control's diagnostic mode.

Kenmore i5 Lo or i5 Hi ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about i5 Lo or i5 Hi.

Can I clear i5 Lo or i5 Hi myself?
Note whether the display reads i5 Lo or i5 Hi. If it comes back, it needs a visit.
How do I read codes on a Kenmore Trio?
Sears describes a diagnostic mode reached from the control panel, using Lock, Freezer, Refrigerator and Acela Ice. Codes appear after the sensor checks and the filter timer.
Can the i5 sensor on a Kenmore Trio be replaced alone?
No. Sears says it is part of the ice maker.
What is the first check for i5 on a Kenmore?
The wiring between the ice maker and the control board.

Back to your everyday

Still showing i5 Lo or i5 Hi?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair