The ice bin lifted out of a door ice maker and set in a kitchen sink, a solid lump of fused cubes wrapped around the spiral auger at its base.

Bosch E03 on the dispenser panel

Bosch links E03 to the user interface of the dispenser.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Dispenser and auger
  • Ice dispenser and auger repair
  • Source: Bosch

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

Before you book,
in this order.

Each step comes from Bosch's own guidance for E03 on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

Switch the breaker off for 30 seconds and back on.

02

Try each dispenser selection and note which ones respond.

03

If E03 returns, book a visit; the interface board or its connection needs testing.

Still there?

It usually turns into ice dispenser and auger repair. Book with the code and the model number.

What not to do

E03 does not mean the ice maker has stopped; it concerns the panel on the door. It is also not a water supply problem.

What you may
notice with it.

The ice maker problems E03 tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

Where E03 usually leads

Ice dispenser and auger repair.

Auger, auger motor, crusher or chute flap · low to moderate.

In Bosch's own words

There is a dispenser user interface fault/error.
Bosch refrigeration error codes Bosch refrigeration error codes

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch models with an external ice and water dispenser.

Bosch E03 ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about E03.

Can I clear E03 myself?
Switch the breaker off for 30 seconds and back on. If it comes back, it needs a visit.
My Bosch shows E03 but the ice bin is full. What is wrong?
Bosch assigns E03 to the dispenser's control panel, not to the ice maker. The ice maker can keep filling the bin while the panel fails to start the dispenser.
Can water on the Bosch dispenser panel cause E03?
Bosch does not name water as a cause. Wipe the panel dry and do a breaker reset; if E03 stays, the interface needs testing.
Is Bosch E03 the same as E02?
No. E02 concerns the ice maker and the ice and water controls; E03 concerns the dispenser panel only.

Back to your everyday

Still showing E03?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair