The ice bin lifted out of a door ice maker and set in a kitchen sink, a solid lump of fused cubes wrapped around the spiral auger at its base.

Sub-Zero 30 9 01: bulk ice switch stuck closed

On Classic (BI) models with a dispenser, 30 9 01 means the bulk ice switch is stuck in the closed position.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Dispenser and auger
  • Ice dispenser and auger repair
  • Source: Sub-Zero

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

Before you book,
in this order.

Each step comes from Sub-Zero's own guidance for 30 9 01 on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

Check that nothing is pressing on the dispenser pad or wedged near the ice chute.

02

Switch the unit's home breaker off for 30 seconds, then back on.

03

If 30 9 01 comes back, stop using ice dispensing and book a visit.

Still there?

It usually turns into ice dispenser and auger repair. Book with the code and the model number.

What not to do

30 9 01 says nothing about cube production. It concerns a switch on the dispensing side.

What you may
notice with it.

The ice maker problems 30 9 01 tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

Where 30 9 01 usually leads

Ice dispenser and auger repair.

Auger, auger motor, crusher or chute flap · low to moderate.

In Sub-Zero's own words

Bulk ice switch stuck closed
Sub-Zero answer: Classic ice dispenser closed error 30 9 01 Sub-Zero answer: Classic ice dispenser closed error 30 9 01

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Sub-Zero Classic (BI) models with an ice and water dispenser.

Sub-Zero 30 9 01 ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about 30 9 01.

Can I clear 30 9 01 myself?
Check that nothing is pressing on the dispenser pad or wedged near the ice chute. If it comes back, it needs a visit.
What is the bulk ice switch on a Sub-Zero dispenser?
It is one of the switches the control reads to manage ice delivery through the dispenser. When it reports closed all the time, the control flags 30 9 01.
Can a stuck dispenser paddle cause 30 9 01 on my Sub-Zero?
Anything holding a switch closed can. Clear the dispenser area and reset the breaker first; if the code returns with nothing touching the controls, the switch itself needs testing.
Does 30 9 01 stop my Sub-Zero from making ice?
Not by itself. The code points at the dispensing side; cubes may still collect in the bin even if dispensing misbehaves.

Back to your everyday

Still showing 30 9 01?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair