Bosch E02: the ice maker or its controls
Bosch gives E02 two possible causes: an ice maker that is not working, or a communication problem among the controls that run ice and water.
Mon–Sat, 8am–8pm
- Control board and communication
- Ice maker control and sensor repair
- Source: Bosch
Book a visit
Three short steps, about a minute.
or call (844) 773-0701
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E02
actually means.
Bosch gives E02 two possible causes: an ice maker that is not working, or a communication problem among the controls that run ice and water. Both stop ice production, and telling them apart takes a test of the ice maker, the harness and the boards.
Bosch ice maker display
What to do when E02 shows on the ice makerKind of codeControl board and communication
The boards that run the ice maker stopped hearing each other, or one of them failed: the main control lost contact with the dispenser panel or the ice maker module, or a board reported an electrical problem of its own. Water that dripped onto a connector and a loose harness are checked before a board is ordered by model number. If the ice maker keeps tripping the breaker, leave it off until the visit.
Usually leads toIce maker control and sensor repair
The control board, the thermistors, the bin sensor and the wiring that decide when an ice maker fills, freezes and stops, tested and repaired when a light flashes, a code shows, a breaker trips or the ice never stops coming.
Shows up asNo Ice Coming From the Ice Maker
The mold sits empty or holds one frozen batch that never drops, the bin stays bare for days, and the dispenser gives water as usual: an ice maker not making ice while the rest of the appliance carries on normally.
MakeBosch
Repair visits for Bosch ice makers, from a slow fill to a bin that stays empty.
SourceBosch refrigeration error codes
Bosch French door and bottom-freezer models with an ice maker.
Before you book,
in this order.
Each step comes from Bosch's own guidance for E02 on its ice makers. Follow it to the end: the last card says whether this is a visit.
Switch the breaker off for 30 seconds and back on, as Bosch advises.
Watch whether the dispenser panel responds and the ice maker cycles over the next few hours.
If E02 comes back, book a visit so the ice maker and its wiring can be tested.
Still there?
It usually turns into ice maker control and sensor repair. Book with the code and the model number.
What not to do
E02 is not a cooling code, so the fresh food and freezer sections usually stay cold. It also is not the dispenser panel code, which Bosch lists as E03.
What you may
notice with it.
The ice maker problems E02 tends to arrive with. Answer these at the ice maker before anyone is booked.
All problems
Where E02 usually leads
Ice maker control and sensor repair.
Bosch
ice makers.
Repair visits for Bosch ice makers, from a slow fill to a bin that stays empty.
Bosch ice maker repairMore Bosch codes
Control board and communication on other makes
Door ice maker
The ice maker that feeds the dispenser on the outside of a door: tucked into an insulated box in the left door of a French door model, or at the top of the freezer side of a side-by-side, with a chute and an auger carrying cubes to your glass.
Freezer ice maker
The ice maker that sits inside the freezer compartment itself, a tray that twists or a mold with a heater and an ejector, dropping cubes into a bin or drawer you open by hand, with no dispenser on the door.
In Bosch's own words
The icemaker is faulty or the ice water system controls have a communiciation issue.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch French door and bottom-freezer models with an ice maker.
Bosch E02 ice maker repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E02.
Can I clear E02 myself?
Does Bosch E02 always mean a new ice maker?
Will a power reset clear E02 on my Bosch?
Can a Bosch keep cooling normally while E02 shows?
Back to your everyday
Still showing E02?
Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.