JennAir column Replace Filter icon blinking
On JennAir columns the Replace Filter icon flashes through every water dispense once the filter is due.
Mon–Sat, 8am–8pm
- Water supply and fill
- Ice maker water inlet valve repair
- Source: JennAir
Book a visit
Three short steps, about a minute.
or call (844) 773-0701
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Replace Filter blinking
actually means.
On JennAir columns the Replace Filter icon flashes through every water dispense once the filter is due. After 14 days without a change it blinks seven times with three tones at the end of dispensing, and it stays lit until a reset is done.
JennAir ice maker display
What to do when Replace Filter blinking shows on the ice makerKind of codeWater supply and fill
The ice maker asked for water and got too little, too slowly or none at all, or water kept arriving after the fill should have ended. A closed shutoff, a kinked line, a clogged filter and low house pressure are ruled out before the water inlet valve is replaced or the fill tube is thawed. If water is on the floor, close the supply valve before reading anything on the display.
Usually leads toIce maker water inlet valve repair
The electric valve that lets water into the ice maker, tested and replaced when it will not open, opens only partway, or keeps dripping after it should have closed.
Shows up asIce Tastes or Smells Bad
The ice tastes bad or smells stale, musty, of plastic or of whatever else is in the freezer, even though a glass of tap water tastes fine.
MakeJennAir
JennAir ice maker visits, from a quiet dispenser to cubes that come out cloudy.
SourceJennAir column owner's manual W11362247C (Wayback copy, Mar 2026)
JennAir built-in columns (owner's manual W11362247C).
Before you book,
in this order.
Each step comes from JennAir's own guidance for Replace Filter blinking on its ice makers. Follow it to the end: the last card says whether this is a visit.
Replace the EveryDrop filter.
Complete the filter reset from the control panel.
Dispense and discard water to flush air from the line.
If the icon stays lit after the reset, book a visit.
Still there?
It usually turns into ice maker water inlet valve repair. Book with the code and the model number.
What not to do
The blinking icon is not a leak signal. It counts filter life.
What you may
notice with it.
The ice maker problems Replace Filter blinking tends to arrive with. Answer these at the ice maker before anyone is booked.
All problems
Ice Tastes or Smells Bad
5 causes, cheapest first
Where Replace Filter blinking usually leads
Ice maker water inlet valve repair.
JennAir
ice makers.
JennAir ice maker visits, from a quiet dispenser to cubes that come out cloudy.
JennAir ice maker repairMore JennAir codes
Water supply and fill on other makes
Freezer ice maker
The ice maker that sits inside the freezer compartment itself, a tray that twists or a mold with a heater and an ejector, dropping cubes into a bin or drawer you open by hand, with no dispenser on the door.
Undercounter ice maker
A built-in residential ice maker that lives under a kitchen, bar or basement counter, making clear cubes or chewable nugget ice on its own cooling system, with a water line in and a gravity drain or a small drain pump out.
In JennAir's own words
the “Replace Filter” icon will blink seven times and
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. JennAir built-in columns (owner's manual W11362247C).
JennAir Replace Filter blinking ice maker repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Replace Filter blinking.
Can I clear Replace Filter blinking myself?
Why does my JennAir column beep three times after I get water?
How often should a JennAir column filter be replaced?
Why is Replace Filter still lit on my JennAir after a new filter?
Back to your everyday
Still showing Replace Filter blinking?
Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.