JennAir undercounter ice maker Clean light blinking
JennAir's freestanding ice maker help treats a blinking Clean light as a cleaning cycle in process.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: JennAir
Book a visit
Three short steps, about a minute.
or call (844) 773-0701
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Clean light blinking
actually means.
JennAir's freestanding ice maker help treats a blinking Clean light as a cleaning cycle in process. If the cycle was interrupted, the light keeps blinking until Clean is pressed again, and Cleaning Complete lights at the end.
JennAir ice maker display
What to do when Clean light blinking shows on the ice makerKind of codeMode, not a failure
Something the ice maker was switched into, often without anyone noticing, rather than something that broke: ice turned off from the panel or by the wire arm lifted while reaching into the bin, a control lock, a Sabbath setting, a cleaning cycle still running, a reminder that the water filter is due. No part has worn out, and the ice maker's own buttons or arm put it right.
Usually leads toNo repair
Let a cycle you started run to Cleaning Complete.
Shows up asIce Maker Light Flashing
An ice maker light flashing where it used to glow steadily: a blinking power or ice light, a flashing clean or descale symbol, an add-water light, or a status light on the ice maker itself.
MakeJennAir
JennAir ice maker visits, from a quiet dispenser to cubes that come out cloudy.
SourceJennAir Product Help: Cleaning Light Blinking - Freestanding Ice Maker
JennAir freestanding (built-in or undercounter) ice makers covered by its Product Help pages.
Before you book,
in this order.
Each step comes from JennAir's own guidance for Clean light blinking on its ice makers. Follow it to the end: the last card says whether this is a visit.
Let a cycle you started run to Cleaning Complete.
Press Clean if the cycle was cut off by a power cut or an opened door.
Restart the unit at the breaker if the light will not respond, then press Clean.
Book a visit if it keeps blinking after that.
Cleared?
The ice maker is filling and dropping cubes again and no part was needed. If the same code returns during the next harvest, or water shows up on the floor again, book it as a new problem.
What not to do
The blinking Clean light is not a component report. It is tied to the cleaning cycle.
What you may
notice with it.
The ice maker problems Clean light blinking tends to arrive with. Answer these at the ice maker before anyone is booked.
All problems
Ice Maker Light Flashing
6 causes, cheapest first
No repair indicated
Nothing to repair.
Something the ice maker was switched into, often without anyone noticing, rather than something that broke: ice turned off from the panel or by the wire arm lifted while reaching into the bin, a control lock, a Sabbath setting, a cleaning cycle still running, a reminder that the water filter is due. No part has worn out, and the ice maker's own buttons or arm put it right.
JennAir
ice makers.
JennAir ice maker visits, from a quiet dispenser to cubes that come out cloudy.
JennAir ice maker repairMore JennAir codes
Mode, not a failure on other makes
Freezer ice maker
The ice maker that sits inside the freezer compartment itself, a tray that twists or a mold with a heater and an ejector, dropping cubes into a bin or drawer you open by hand, with no dispenser on the door.
Undercounter ice maker
A built-in residential ice maker that lives under a kitchen, bar or basement counter, making clear cubes or chewable nugget ice on its own cooling system, with a water line in and a gravity drain or a small drain pump out.
In JennAir's own words
The Clean button will continue to blink, during the Clean Cycle, indicating that the cleaning cycle is in process.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. JennAir freestanding (built-in or undercounter) ice makers covered by its Product Help pages.
JennAir Clean light blinking ice maker repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Clean light blinking.
Can I clear Clean light blinking myself?
What does a blinking Clean light mean on a JennAir undercounter unit?
Why clean a JennAir clear-ice unit at all?
How will I know the JennAir clean cycle is finished?
Back to your everyday
Still showing Clean light blinking?
Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.