GE undercounter ice maker with several control lights flashing
When different lights on the control panel of GE's 15-inch built-in ice maker flash at the same time, GE's manual lists a component or sensor problem as the cause.
Mon–Sat, 8am–8pm
- Control board and communication
- Ice maker control and sensor repair
- Source: GE
Book a visit
Three short steps, about a minute.
or call (844) 773-0701
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Several control lights flashing
actually means.
When different lights on the control panel of GE's 15-inch built-in ice maker flash at the same time, GE's manual lists a component or sensor problem as the cause. Unlike the water pattern, this one has no owner fix in the manual beyond service.
GE ice maker display
What to do when Several control lights flashing shows on the ice makerKind of codeControl board and communication
The boards that run the ice maker stopped hearing each other, or one of them failed: the main control lost contact with the dispenser panel or the ice maker module, or a board reported an electrical problem of its own. Water that dripped onto a connector and a loose harness are checked before a board is ordered by model number. If the ice maker keeps tripping the breaker, leave it off until the visit.
Usually leads toIce maker control and sensor repair
The control board, the thermistors, the bin sensor and the wiring that decide when an ice maker fills, freezes and stops, tested and repaired when a light flashes, a code shows, a breaker trips or the ice never stops coming.
Shows up asNo Ice Coming From the Ice Maker
The mold sits empty or holds one frozen batch that never drops, the bin stays bare for days, and the dispenser gives water as usual: an ice maker not making ice while the rest of the appliance carries on normally.
MakeGE
GE ice maker repair in ordinary kitchens, covering the freezer tray, the door dispenser and the water line.
SourceGE Appliances 15-inch nugget ice maker owner's manual 49-1000610 (UNC15NP)
GE-branded 15-inch panel-ready nugget ice maker UNC15NP (owner's manual 49-1000610).
Before you book,
in this order.
Each step comes from GE's own guidance for Several control lights flashing on its ice makers. Follow it to the end: the last card says whether this is a visit.
Note exactly which lights are flashing and whether they flash together or in a sequence.
Turn the ice maker off at the breaker for about a minute and back on to see if the pattern clears.
Book a visit if the lights start flashing again.
Still there?
It usually turns into ice maker control and sensor repair. Book with the code and the model number.
What not to do
This is not the alternating Making Ice and Filter pattern, which means low water. It also does not name the failed part; the component has to be found with a meter.
What you may
notice with it.
The ice maker problems Several control lights flashing tends to arrive with. Answer these at the ice maker before anyone is booked.
All problems
Where Several control lights flashing usually leads
Ice maker control and sensor repair.
GE
ice makers.
GE ice maker repair in ordinary kitchens, covering the freezer tray, the door dispenser and the water line.
GE ice maker repairMore GE codes
Control board and communication on other makes
Door ice maker
The ice maker that feeds the dispenser on the outside of a door: tucked into an insulated box in the left door of a French door model, or at the top of the freezer side of a side-by-side, with a chute and an auger carrying cubes to your glass.
Freezer ice maker
The ice maker that sits inside the freezer compartment itself, a tray that twists or a mold with a heater and an ejector, dropping cubes into a bin or drawer you open by hand, with no dispenser on the door.
Undercounter ice maker
A built-in residential ice maker that lives under a kitchen, bar or basement counter, making clear cubes or chewable nugget ice on its own cooling system, with a water line in and a gravity drain or a small drain pump out.
In GE's own words
Different lights on control panel will be flashing
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. GE-branded 15-inch panel-ready nugget ice maker UNC15NP (owner's manual 49-1000610).
GE Several control lights flashing ice maker repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Several control lights flashing.
Can I clear Several control lights flashing myself?
What does it mean when all the lights flash on a GE undercounter ice maker?
Should I keep resetting my GE nugget ice maker if the lights keep flashing?
How is this different from the alternating light pattern on the GE?
Back to your everyday
Still showing Several control lights flashing?
Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.