The dispenser panel on the freezer door of a stainless French door model, a small lock symbol and an ice-off symbol lit, the ice chute below empty and dry.

GE undercounter nugget ice maker Time to Clean light

The Time to Clean light on GE's 15-inch nugget ice maker is a timer.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: GE

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

Before you book,
in this order.

Each step comes from GE's own guidance for Time to Clean light on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

If the light is steady, order the ice maker cleaner so it is on hand.

02

If it is flashing, run the cleaning process in the Care and Cleaning section of the manual; press and hold Clean for 3 seconds to start it.

03

If the light stays on after a complete cleaning cycle, book a visit.

Cleared?

The ice maker is filling and dropping cubes again and no part was needed. If the same code returns during the next harvest, or water shows up on the floor again, book it as a new problem.

What not to do

The light is not a sensor reading of scale inside the unit. It counts time, so a home with hard water may need cleaning sooner than the light asks.

What you may
notice with it.

The ice maker problems Time to Clean light tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

No repair indicated

Nothing to repair.

Something the ice maker was switched into, often without anyone noticing, rather than something that broke: ice turned off from the panel or by the wire arm lifted while reaching into the bin, a control lock, a Sabbath setting, a cleaning cycle still running, a reminder that the water filter is due. No part has worn out, and the ice maker's own buttons or arm put it right.

In GE's own words

6 months indicating it is time to clean the machine.
GE Appliances 15-inch nugget ice maker owner's manual 49-1000610 (UNC15NP) GE Appliances 15-inch nugget ice maker owner's manual 49-1000610 (UNC15NP)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. GE-branded 15-inch panel-ready nugget ice maker UNC15NP (owner's manual 49-1000610).

GE Time to Clean light ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about Time to Clean light.

Can I clear Time to Clean light myself?
If the light is steady, order the ice maker cleaner so it is on hand.
Why is the Time to Clean light on my GE ice maker steady and not flashing?
Steady means order the cleaner; the unit is giving you a month of notice. When it starts flashing, it is time to run the cleaning process.
Does my GE nugget ice maker stop making ice when Time to Clean flashes?
The manual treats the light as a reminder, not a shutdown. Skipping cleaning lets scale build up, which GE lists among the causes of a low ice rate.
What if the Time to Clean light stays on after I cleaned the GE?
Make sure the cleaning cycle ran to the end rather than being stopped partway. If it did and the light will not go out, book a visit.

Back to your everyday

Still showing Time to Clean light?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair