The dispenser panel on the freezer door of a stainless French door model, a small lock symbol and an ice-off symbol lit, the ice chute below empty and dry.

GE undercounter nugget ice maker Replace Filter light

On GE's 15-inch nugget ice maker the Replace Filter light is lit steady when it is time to order a filter and flashes when it is time to replace it.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: GE

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

Before you book,
in this order.

Each step comes from GE's own guidance for Replace Filter light on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

If the light is steady, order a replacement filter.

02

If it is flashing, install the new filter behind the access door at the bottom of the unit.

03

Press Filter Reset after the change so the light goes out.

04

If the light keeps flashing with a new filter and a reset, book a visit.

Cleared?

The ice maker is filling and dropping cubes again and no part was needed. If the same code returns during the next harvest, or water shows up on the floor again, book it as a new problem.

What not to do

The Replace Filter light alone is not a water-supply problem. When it alternates with the Making Ice light instead, GE means the water supply is low.

What you may
notice with it.

The ice maker problems Replace Filter light tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

No repair indicated

Nothing to repair.

Something the ice maker was switched into, often without anyone noticing, rather than something that broke: ice turned off from the panel or by the wire arm lifted while reaching into the bin, a control lock, a Sabbath setting, a cleaning cycle still running, a reminder that the water filter is due. No part has worn out, and the ice maker's own buttons or arm put it right.

In GE's own words

FILTER RESET - Press after changing filter to reset filter timer.
GE Appliances 15-inch nugget ice maker owner's manual 49-1000610 (UNC15NP) GE Appliances 15-inch nugget ice maker owner's manual 49-1000610 (UNC15NP)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. GE-branded 15-inch panel-ready nugget ice maker UNC15NP (owner's manual 49-1000610).

GE Replace Filter light ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about Replace Filter light.

Can I clear Replace Filter light myself?
If the light is steady, order a replacement filter.
Where is the filter on a GE built-in nugget ice maker?
Behind the water filter access door at the bottom front of the unit. The same door hides the label you need to connect the unit to Wi-Fi.
Why is my GE ice maker filter light still on after a new filter?
The timer only restarts when you press Filter Reset. If you pressed it and the light still flashes, the reset or the control needs checking.
Is a steady Replace Filter light on a GE ice maker urgent?
No. Steady means order a filter; flashing means it is time to change it.

Back to your everyday

Still showing Replace Filter light?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair