The ice compartment high in a French door model's left door opened with its cover off, a small sensor clipped to the side of the ice maker and its thin wire running to a plug.

Viking nugget model: ICE and NO WATER lamps blinking together

On Viking's FNIU515D, ICE and NO WATER blinking together is the evaporator temperature sensor error.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Temperature sensors
  • Ice maker control and sensor repair
  • Source: Viking

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

What ICE and NO WATER lamps blinking
actually means.

On Viking's FNIU515D, ICE and NO WATER blinking together is the evaporator temperature sensor error. The sensor at the evaporator outlet is disconnected or shorted, so the control cannot manage the freezing process.

Viking ice maker display

What to do when ICE and NO WATER lamps blinking shows on the ice maker

Before you book,
in this order.

Each step comes from Viking's own guidance for ICE and NO WATER lamps blinking on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

Write down which two lamps are blinking before switching anything off.

02

Switch the unit off and back on once to see whether the pattern returns.

03

Book a visit; Viking's action is to repair the sensor part before restarting.

Still there?

It usually turns into ice maker control and sensor repair. Book with the code and the model number.

What not to do

This is not the water supply error, even though the NO WATER lamp is involved. That error blinks the NO WATER lamp alone.

What you may
notice with it.

The ice maker problems ICE and NO WATER lamps blinking tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

Where ICE and NO WATER lamps blinking usually leads

Ice maker control and sensor repair.

Control board, thermistor or bin sensor · moderate to highest.

In Viking's own words

When the EVA temperature sensor at the
Viking FNIU515D 15-inch panel-ready nugget ice model owner's guide (Viking's Middleby CDN PDF) Viking FNIU515D 15-inch panel-ready nugget ice model owner's guide (Viking's Middleby CDN PDF)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Viking FNIU515D panel-ready nugget model with drain pump; the three lamps are ICE, NO WATER and DRAIN on the display panel.

Viking ICE and NO WATER lamps blinking ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about ICE and NO WATER lamps blinking.

Can I clear ICE and NO WATER lamps blinking myself?
Write down which two lamps are blinking before switching anything off. If it comes back, it needs a visit.
What does ICE plus NO WATER blinking mean on my Viking nugget ice maker?
It means the evaporator temperature sensor is disconnected or shorted. The unit cannot freeze properly without that reading.
Can I fix the evaporator sensor on a Viking myself?
Viking's action is to check the sensor and its attachment and restart after the sensor is repaired. The sensor sits inside the refrigeration section, so it is a technician's job.
Will my Viking make nugget ice with this sensor code?
Not reliably. The control relies on that sensor to run each cycle, so production stops or becomes erratic.

Back to your everyday

Still showing ICE and NO WATER lamps blinking?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair