The ice bin lifted out of a door ice maker and set in a kitchen sink, a solid lump of fused cubes wrapped around the spiral auger at its base.

Sub-Zero 30 9 86: the chute motor ran out of time

On Classic (BI) built-in models with a dispenser, 30 9 86 means the chute motor timed out.

(844) 773-0701

Mon–Sat, 8am–8pm

  • Dispenser and auger
  • Ice dispenser and auger repair
  • Source: Sub-Zero

Book a visit

Three short steps, about a minute.

or call (844) 773-0701

Before you book,
in this order.

Each step comes from Sub-Zero's own guidance for 30 9 86 on its ice makers. Follow it to the end: the last card says whether this is a visit.

01

Look at the ice chute for ice, frost or a stray cube that could block the door and clear it gently.

02

Switch the unit's home breaker off for 30 seconds and back on.

03

If 30 9 86 returns, stop dispensing ice and book a visit.

Still there?

It usually turns into ice dispenser and auger repair. Book with the code and the model number.

What not to do

30 9 86 is not an ice maker or water supply problem. It concerns the small motor and door at the dispenser chute.

What you may
notice with it.

The ice maker problems 30 9 86 tends to arrive with. Answer these at the ice maker before anyone is booked.

All problems

Where 30 9 86 usually leads

Ice dispenser and auger repair.

Auger, auger motor, crusher or chute flap · low to moderate.

In Sub-Zero's own words

Chute motor timed out
Sub-Zero answer: Classic built-in error code 30 9 86 Sub-Zero answer: Classic built-in error code 30 9 86

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Sub-Zero Classic (BI) built-in models with an external ice dispenser.

Sub-Zero 30 9 86 ice maker repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child filling two glasses with ice from the door dispenser in a bright family kitchen
For the heart of your home.

Questions
about 30 9 86.

Can I clear 30 9 86 myself?
Look at the ice chute for ice, frost or a stray cube that could block the door and clear it gently. If it comes back, it needs a visit.
What does the chute motor do on a Sub-Zero dispenser?
It moves the small door at the top of the ice chute so cubes can pass and then seals the chute again. 30 9 86 means that move took longer than the control allows.
Can frost at the chute trigger 30 9 86 on a Sub-Zero?
Ice or frost around the chute door can slow or stop it, so a quick look is worth it. If the chute is clear and the code comes back, the motor or its linkage is the next check.
Is it safe to keep dispensing water with 30 9 86 showing?
The code concerns the ice chute. Water dispensing uses a separate path, but if anything else misbehaves, stop using the dispenser and book a visit.

Back to your everyday

Still showing 30 9 86?

Book with the code or the blink pattern written exactly as the ice maker shows it, the full model number, and whether there is any water on the floor — when there is a code, that is where the diagnosis starts.

(844) 773-0701 Schedule a repair